Kennametal 4032787 Roughing and Finishing End Mill, 6.00 mm Dia, 3 Flute, Solid Carbide, 38.00 mm

Features:

• Economic solid carbide end mill with short style shanks, saving expensive carbide
• Not recommended for reconditioning
• Extremely stable cutting conditions due to short design
• Center cutting for plunging and ramping operations
• Unequal flute spacing for chatter-free machining at highest feed rates
• Roughing & Finishing End Mill: 6.00 mm Dia, 3 Flute, Solid Carbide
• 8.00 mm LOC, 38.00 mm OAL, 6.00 mm Shank Dia, 38 deg Helix, AlTiN Finish, Single End, Kennametal UEDE
• Coated fine-grain grade with PVD multilayer (AlTiN). KC643M is a very thin and hard PVD coating particularly suited for cutting steel, cast iron, stainless steel (wet), and titanium (wet). This grade can be used for materials with hardness up to 52 HRC.

Application:

• Plunge Milling
• Ramping: Blank
• Slotting: Square End
• Side Milling / Shoulder Milling: Square End
• Tool Dimensions: Flute Configuration: 3
• Helix Angle: 38°
• Corner Style: Square End